Sunday, November 6, 2011
Build Session #6 - October 20th
H, Ryan and I went through the calibration process for the servo motors. It required a volt-meter so we made a trip to Home Depot to buy one.
But we were unable to get the MakerBot and computer to communicate to each other and therefore the firmware would not load onto the motherboard. All we could figure out was that it seemed to have something to do with using the com port. We called it quits 11pm. Ryan went home and H and I went downtown and met up with Steve Lehman for some wildness.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment